Algodoo

Can someone make a skin for this? I'll be happy to put it here with credits!

I didn't expect this to work half as good. I started at 400 Hz, but it turned out pretty well and i could lower the frequency to 300. (I guess it would work at 250 though)
It has my first legit burst mech (2 round burst) and I think I can adapt it to 3 round too. But it's enough like that.
The fire selector is quite weird: if the red arrow is facing to the left, then it's in SAFE mode (green X). If it's facing upwards and the dial is leftmost, then it's in FULL AUTO (orange-red F), if it's in the middle it's SEMI (yellow S), and if it's rightmost then it's in BURST mode (orange 2). Note that you can only put the safe when it's leftmost

So, the controls are all by drag tool (I reccomend 1*10^8 but you can use less) and the belt is a little bit finicky. If any round falls off, you can take it and put it on the belt again, it will self-accomodate.

To get the belt off, you have to drag the triger guard all the way until it stops at 45º. When it's there, the belt will either fall off, or you'll need to drag it down. then if you want to load a new one you have to put the trigger guard in NORMAL state (0º) and put the new belt with some pressure.

To cycle action drag the green box back.

To fire either drag the trigger back or press W



If you feel adventurous, try to understand my select-fire mechanism!

Please rate and comment!