An easily programmable computer with built-in display.
Now with repaired CPU (R2)
With example floppy. Before use press F2.
Features:
AHOX X7 R2 CPU
Built-In display with Text, Texture and texture matrix support
Keyboard
Floppy drive
Peripheral Interface (PI) connector
How can i programm it?
Put commands into a core box of the floppy inside the Appearance menu>Text and write commands inside "[[ here ]]" brackets.
But be careful! If something will went wrong, algodoo will fall!
What commands can i use?
["WRITE", "Hello world"] - This command will add "Hello World" to the display.
["CLEAR"] - Clears screen.
["TPIC", "wood.png"] - This will make monitor texture to wood.png .
["TMAT", [1.0, 0.0, 0.0, 0.0, 1.0, 0.0, 0.0, 0.0, 1.0]] - This will change texture matrix to [1.0, 0.0, 0.0, 0.0, 1.0, 0.0, 0.0, 0.0, 1.0]
["RMAT"] - Resets monitor texture matrix to default.
["RPIC"] - Resets monitor texture.
["RESET"] - Restarts computer. Works like if you'll press F2.
["KEY", "y", 2, 1] - If you'll press key "Y", the command reading jumps to 2, if you won't press it it will jump to 1.
["CUSTOM", "scene.my.variable = 1"] - This will set your variable to value you wrote. (you can write here everything to execute, but it is important to write " to start and end like this.
["DELAY", 10] - This will wait 10 seconds until it will jump to next command.
["PI.INFO"] - This will show text from pin 1 of PI.
["PI.READ"] - This will show text from pin 2 of PI.
["PI.SEC", 25] - This will set PI pin 3 controllerAcc to 25.
["PI.WRITE", "Text to write"] - This will set PI pin 4 to text you wrote.
That's all
. If you look like this:
try to experiment with some commands to get how it works yourself.
Enjoy! I hope you'll post some programmed floppies here!!! Comment and rate please!