Algodoo

bad

Very nice rendition! You chose to omit the magazine safety and the browning short-recoil, which is not a bad decision. A few tips though:

- The skin is great. I can see that you put a lot of effort in it. The colors are pleasant and the shading convincing. Don't forget to add details though (slide serrations, hammer ring chamfer...)

-The internals are straightforward and functional. I realised I fired full auto because the disconnector doesn't seem to do its job (I recommend adding a trigger stop block to avoid extra movement due to the drag tool, just in case). Also, the feed angle is a bit too high. The cartridges seem to have trouble getting chambered.

-Finally, I recommend strengthening the springs in order to balance the heavy mag.

Great gun! I will rate when finally released.

Very nice! Love the skin, but the magazine is in front of the gun. There seems to be a slight problem with feeding and the firing pin doesn't seem to be able to hold itself back from the force of the slide going forward. Other than that seems like a great gun

Awesome ejection!
What I always say, if you want more firing rate, lower the barrel so your rounds don't have to go up so much! Also, try using gradients when you can (look on my scenes for the gradient pack)