make lasers able to cut when speed of light is low

[Chronos]

i tried to make a cutter laser with the speed of light set low, so it bends down. however, it doesnt work unless the speed of light it set pretty fast. i think you should be able to cut even with a low speed of light

[tatt61880]

Support.

Btw, at Algodoo v1.6.0, the cutter-laser seems to work only when the light through over the geometry by one segment.
i.e. the lights of laser are shown as segments when speed of light is slow, therefore the cutter doesn't works (by the specification of cutter laser of v1.6.0). On the other hand, even if speed of light is slow, the cutter-laser works when the light through over the geometry by one segment.

[immibis]

Support.

[Fujitsu]

IN AN EFFORT TO RAISE MY POST COUNT

support.

[RicH]

lol, you wrote my name wrong. I'm getting popular with that post. But anyway,

support.

[Sniperkasa]

Support +
Should the laser be able to cut out an "bow" ?

[Sonic]

Support.

Just to raise my post count

[Rhett97]

Not very much use but...

if suggestion = "good" then print "Support"x10

supportsupportsupportsupportsupportsupportsupportsupportsupportsupportsupport

[Fujitsu]

Not very much use but...

if suggestion = "good" then print "Support"x10

supportsupportsupportsupportsupportsupportsupportsupportsupportsupportsupport

I believe the script would be

Code: Select all

Oncollide=(e)=>{Scene.my.suggestion > 9000 ? {Scene.my.support * 10} : {Scene.my.refuse * 10}}

[Chronos]

Support +
Should the laser be able to cut out an "bow" ?

yes. yes it should. it shouldnt cut out an straight line, nor an angled line, but an bow (shamelessly pointing out embarrasing stupid typos FTW! )

Not very much use but...

if suggestion = "good" then print "Support"x10

supportsupportsupportsupportsupportsupportsupportsupportsupportsupportsupport

I believe the script would be

Code: Select all

Oncollide=(e)=>{Scene.my.suggestion > 9000 ? {Scene.my.support * 10} : {Scene.my.refuse * 10}}

who said he was using thyme?

[Altro]

support.

can also be used w/ magnets for curvy cuts and dents