Sim Frequency loading confirmation

[electronicboy]

Recently there has been a few scene which change sim.frequency so that they can work properly, while the user can normally just push a button before closing algodoo, sometimes a user doesn't finish the scene and can't see the instruction to press a button that will change it back to 100HZ

My suggestion is, when opening algodoo, if the sim.frequency is not at 100HZ the user is informed and asked if they want the restore it to the default value.

[Kilinich]

Not only frequency, it's many settings (like target penetration) I don't want to other's scene can alter in my config...
I don't come with suggestion but we must think of it...

[electronicboy]

I have to agree.
I know about the reset button but that wipes the whole config but i am sure that there are a few people on this forum who have custom configs and won't be happy if they have to press it because of a bad scene,
Maybe the reset screen should have a subsections for some sections, like the sph. and sim. variables/

[Rideg]

Is there a way to save the sim.frequency in the scene folder so if you save a scene at 500Hz it will load with 500Hz and restore when making a new scene or opening a saved scene with 100Hz. I'm just thinking out loud here

[electronicboy]

saving stuff like that in the scene was suggested in multiple topics where someone has had a problem e.g. The bouncy water.

And we all know what happened to that suggestion...