Make latches that hold
3 posts • Page 1 of 1
Make latches that hold
I am new to Algodoo, so forgive me if this is naive.
I have a model with moving components and want to add some latches (to hold some moving components in place until another component has rotated into position).
All of my latch designs are failing because if they are small, they do not hold (ie. they wabble and fall apart under tension).
Is there a trick to making small components (like latches) that will hold up to tension?
Thanks,
Bill
I have a model with moving components and want to add some latches (to hold some moving components in place until another component has rotated into position).
All of my latch designs are failing because if they are small, they do not hold (ie. they wabble and fall apart under tension).
Is there a trick to making small components (like latches) that will hold up to tension?
Thanks,
Bill
- justabil
- Posts: 8
- Joined: Tue May 25, 2010 6:38 pm
Re: Make latches that hold
Make the whole mechanism larger.
Also, wrong place to post this.
Also, wrong place to post this.
TheWinkits wrote:They both looks of cuking amazing
-
Chronos - [Most Active Member 2010]
- Posts: 4457
- Joined: Mon Aug 31, 2009 6:00 pm
- Location: Californania
Re: Make latches that hold
Thanks,
Oops...didn't notice I was in FAQ....my bad
Oops...didn't notice I was in FAQ....my bad
- justabil
- Posts: 8
- Joined: Tue May 25, 2010 6:38 pm
3 posts • Page 1 of 1
Return to Webshop FAQ and support
Who is online
Users browsing this forum: No registered users and 3 guests