3D CNC Router

[Antotabo]

This is a typical CNC router setup. You can really cut material manually or run the toolpath contained in scene.my.gcode.

I got to use thyme a lot in this scene for the Numerical Control part and for the material cutting too because of the 2d nature of phun.

The tool path actually loaded make a nice pyramid. The origin of the code is on the top center of the workpiece. so you have to jog to this point andpress x, y, z to make this position the origin. You can also make your really own program (it's just a list of X, Y, Z positions, nothing complicated) and load them in the console!

G-code template to make your program:
scene.my.gcode=[[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0],[0,0,0]]

3D CNC Router

Antotabo

Rating:
Filesize: 106.54 kB
Comments: 21
Ratings: 32

Post your g-codes! I would like to see some!

[Antotabo]

No one have tried to make a toolpath ??

Here is my first video posted on youtube !:

[Dakta]

VERY COOL!

I'd give it a go, but I be busy with finals fast approaching. I'll check it out if I find time.