Alignment Problem [solved]
4 posts • Page 1 of 1
Alignment Problem [solved]
by therestofguys » Sun Feb 01, 2015 5:57 pm
Hi,I'm having an alignment problem in this scene here.
Inside is an engine with a gearbox(area with 3 circles in), the radius of the middle circle will change when shift, but after transforming around, this circle seems no longer aligned at the center of the other circle it's attached on, also if I run it long enough, the circle will dis-align itself, is there a solution to this?
Inside is an engine with a gearbox(area with 3 circles in), the radius of the middle circle will change when shift, but after transforming around, this circle seems no longer aligned at the center of the other circle it's attached on, also if I run it long enough, the circle will dis-align itself, is there a solution to this?
Last edited by therestofguys on Mon Feb 02, 2015 4:28 pm, edited 1 time in total.
-
therestofguys - Posts: 10
- Joined: Sat May 17, 2014 9:34 am
Re: Alignment Problem
by pnvv » Sun Feb 01, 2015 7:41 pm
Um, the middle circle isn't connected to anything. it just sits on to of the bottom one, and gets lower when the radius changes 
(/)(°,,,°)(/)
-
pnvv - Posts: 670
- Joined: Tue Aug 26, 2014 11:46 pm
- Location: Disunited States of America
Re: Alignment Problem
by therestofguys » Mon Feb 02, 2015 9:30 am
So I need an axle or use fixate to connect them or something holding the circles? 
-
therestofguys - Posts: 10
- Joined: Sat May 17, 2014 9:34 am
Re: Alignment Problem [solved]
by pnvv » Mon Feb 02, 2015 5:14 pm
Yeah, just connect the middle wheel to something using an axle so it doesn't try to go anywhere.
(/)(°,,,°)(/)
-
pnvv - Posts: 670
- Joined: Tue Aug 26, 2014 11:46 pm
- Location: Disunited States of America
4 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests
