Algodoo

Welcome to the user manuel of the custom-made ASR Mk. III Sniper Rifle!

This is a fully custom made high-power sniper rifle, capable of firing 2 kilogram
bullets at over 1000m/s while maintaining a high reliability rate!

The weapon was specifically designed to be hard to reload, as that is how
most heavy guns work: Big bullet + Big gun = Slow reload. It has a very
specific reloading procedure so follow the directions exactly please!

NOTE: There is already a round in the chamber of the gun, so to reload,
first fire the round by pressing ENTER or RETURN until the bullet is expelled.

RELOADING:
1. Pull the YELLOW bolt located on top of the gun until the WHITE switch
locks it in place. The Recoil Mechanism should be offline now,

2. Pull the BLUE bolt back until the ORANGE switch locks it in place. The
additional bullets should drop down along with the Restraintment Block,

3. Carefeully pull the RED bolt back until the MAGENTA clips lock the bullet
and the empty shell falls out of the back of the gun,

4. Pull the WHITE switch up. This will restore the Recoil System and close
the Shelldrop Hatch,

5. Pull the ORANGE switch up and then immediatly pull the BLUE bolt
forward. This will raise the additional bullets and reset the Restraintment Block.
Jigging the gun or springlock mechanisms is reccomended if the system falters,

7. Pull the RED bolt forwards until it stops. This will clear the Barrel of obstructions
and finalize the reload procedure,

8. You are ready to fire! Press ENTER or RETURN and the RED hammer should turn
up and activate the bullet. A succesful shot will trip the recoil system, indicated by
the Rear Block flying backwards and the Silencer at the end of the Barrel pulling back
too. If the bullet's springs do not disconnect, manually cut them and execute the reload
procedure.