Algodoo

Enjoy

Here is a suggestion that will make the connecting rod more difficult to be pulled off the crankshaft. In the upper-left corner of the scene next to the "File" tab, you will see a "gear" symbol, which is to change options. Click on that gear, and the options window will open. Then click on the "Simulation" tab, and increase the simulation frequency to 240 Hz. Then close the options window. After you increase the simulation frequency, you will have to increase the "motor torque" to 1000.

After you've made those changes, the engine will be much stronger and more resistant to being tugged by the user. You can increase the simulation frequency even higher, but if you make it too high, then people with slow or older computers will experience a lot of lag which is not good.

Hope you like my suggestion! Enjoy!

Thanks Xray!

It worked!

OH MY GOODNESS WHAT HAPPENED?!!!!!!!!!!!!!!!?????? 15/16TH OF MY ENGINES DISSAPEARED!!!!!!!!!!!!!!!

You're welcome!

Now, what do you mean by "15/16th of my engines disappeared"? Could you be more specific so that I could see for myself what you are talking about?

well, i dont know, but that was probably a glitch, cause the next day it was ok, what i meant about 15/16th of it was missing was that little circle for the conrod and the piston rings and the axle for the crank, which is the ONLY axle on the engine, and i think that black circle for the conrod connection for the piston, oh and i have a v-twin of this coming.

oh and theres 2 engines, the one on the left is the main one and one on right is for example for what would happen if you pulled on the conrod and piston, they would seperate.

I'm STILL confused, but it doesn't matter now that you said it's Okay.

Have fun!

my V-Twin is out if you dont already know XRay

hey little changes today, i detextured the spark plugs

also the pistons, i cut out part of the botom