Algodoo

Em... Just try TotImp3(2) It's axle's torsion load. I'm making 8x8 truck like MAZ 537 with torque converter(CVT 270% + bendConstant³) and 3 gears gearbox

eanayayo, I know how to use that. Just look at the dyno v3. I tried using it here, but it was too unstable.

Use it for motorTorque on axle on other circle with additional bendConstant(or anything else to slow it down). Angvel on this circle changes diameters in CVT by scene.my variable. Sorry for my poor English, I hope you understand that it'll make smooth and limited transmission ratio

"... and I'm going to fix this soon." That's a bold statement. Good luck with that. I played with this and it may be about as good as it gets unless you slow down the load sine wave frequency. It seems to me that you are at the point that if you increase the feedback, it becomes unstable, and if you reduce the feedback, it responds too slow. Hopefully you can prove me wrong. I rated this scene 9, because I like the idea and it works fairly well. This transmission control may work just fine with a spawn motor, since A spawn motor probably has less of a (change in torque)/(change in RPM) slope.

I wish I knew how to scrip like this