Algodoo

May be add more gears? It only tops out at about 30 MPH and what stops it is the rev limiter. I'd say 4 or 5 should do it.

Other than that, this is pretty great. I'll give a 9, it'd be a 10 if the gearbox was better.

Sorry but I don't understand your comment, sorry.

30 MPH? My speed limit on my computer was about 210km/h -> 130MPH
I think you press X to put the short gearbox which allow a big torque but low speed. Press X again and you will go to 130MPH!!! and more (the motor will certainly blow up but whatever !!)

The gear box has already 8 speed, I think it's enough for a truck like this.

But, thank for rating !!

I hope you will enjoy the V 2.0

*facepalm* I'm stupid. I didn't see A/Z to shift gear because it isn't in the scene!!

I would've rated 10 if I saw that. xD

Oh, I'm stupid too, I added so

You can create a new account and rate it 10

Powertested your engine too, does 9000 torque at 40 rad/s so my math gives me ~480 hp

Better than I could do with a V6, I never build them. Mostly I stick with 4 or 8 (or more) in most cases.

it pretty good!

@pnvv Whaou, 480HP !! I'm stunned !!Thank for that information

V6 is a pure wonder, it runs the Nissan GT-R R35

@Kilinich WHAOU, you here, in my scene ?! Thank you !!

2 more things:

- I need a fully operated dashboard (I suck at this ...) with indication for Low/long gearbox, the gear selected, if it's 4 or 6 wheels drive, ignition and of course rpm meter and speed meter (with great needle dial) please
I will upload the new truck (with a better design) where you could work on.

- When i pass the 58 m/s (210km/h) the wheels begins to vibrate ... and i don't remember how to avoid that, please help me =)

About the speed issue, put legacymode = 0 on the wheel axles. If they stretch too much then just increase the density of the stuff they're attached to.

@kilinich - I honestly thought you'd moved on

When i turned them to 0 they act like if they are no axe, the truck "fall"

Did you increase the density of the part that the axle is attached to?

Yes i did it but not enough, I tried 50 then 500 and finally 5000, and it works !!!! Thanks !!

Speed limit: 250 Km/H due to the ruptor of the motor, i will try new parameter to reech 300 Km/H.

I will upload the new version this week-end. I hope...

I might make my own version, if that's ok. I'll probably only use your bodywork, if that's ok.

Yes you can, of course ! With a little credit that' be great