Algodoo

Good job! I knew that this challenge would be a piece of cake for you.

I already knew what needed to be done because I ran into this problem in my CNC Plotter scene. My method of calculating the step rate of each axis was a little more complex than the way you did it (simpler is better), but the concept was basically the same.

I'll send you your prize on the 31st of next month.

Thanks for the compliment. I couldn't resist the challenge. I will be waiting patiently for the big prize.

I'll send it on the 31st of September, and you should receive it on the 31st of November.